CDFLZ - 521-01 WHITE BASE SILATHANE INT/EXT BRUTONEINTERIOR ALKYD SE
- MSDS: CDFLZ
- Manufacturer: BRUNING PAINT CO INC
- Product Name: 521-01 WHITE BASE SILATHANE INT/EXT BRUTONEINTERIOR ALKYD SE
- National Stock Number: 8010-00F052653
Product Identification
Product ID:521-01 WHITE BASE SILATHANE INT/EXT BRUTONEINTERIOR ALKYD SE
MSDS Date:08/01/1993
FSC:8010
NIIN:00F052653
MSDS Number: CDFLZ
Responsible Party
BALTIMORE, MD 21224-4347
US
Emergency Phone: 410-342-3636/3641
Info Phone: 410-342-3636/3641
Cage: EO376
Contractor
Telephone: 800-368-2076
Cage: 85520
Ingredients
STODDARD SOLVENT (PETROLEUM DISTILLATE), MINERAL SPIRITS
CAS: 8052-41-3
RTECS: WJ8925000
Fraction By Weight: 25-50%
OSHA PEL 500 PPM
ACGIH TLV: 100 PPM
TALC (POWDER), (ASBESTOS FREE), TALCUM; HYDROUS MAGNESIUM
CAS: 14807-96-6
RTECS: WW2710000
Fraction By Weight: 0-5%
OSHA PEL 2 MG/CUM (RESP DUST)
ACGIH TLV: 2 MG/CUM (RESP DUST)
MEDIUM ALIPHATIC NAPHTHA (AROMATIC 100), PARAFFIN-NAPTHANES
CAS: 64742-88-7
Fraction By Weight: 0-5%
OSHA PEL 500 PPM
ACGIH TLV: 100 PPM
3.32 TO 3.74 LBS/GAL
RTECS: 9999999VO
Hazards
Routes of Entry: Inhalation:YES Skin:NO Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:MAY CAUSE NOSE, THROAT & EYE
IRRITATION. REPEATED/PROLONGED OVEREXPOSURE TO SOLVENTS MAY CAUSE
PERMANENT BRAIN & NERVOUS SYSTEM DAMAGE.
Explanation of Carcinogenicity:NONE
Effects of Overexposure:IRRITATION, DIZZINESS, HEADACHE, INTOXICATION,
EUPHORIA, UNCONSCIOUSNESS.
First Aid
First Aid:EYES: FLUSH W/LUKE WARM WATER FOR 15 MINS. SKIN: FLUSH WASH
W/COPIOUS AMOUNTS OF LUKE WARM WATER. INHALATION: REMOVE TO FRESH
AIR. RESTORE BREATHING IF REQUIRED. INGESTION: RINSE MOUTH
IMMEDIATELY. GI VE 6-8 OUNCES OF LIQUID. NEVER GIVE ANYTHING BY
MOUTH TO AN UNCONSCIOUS PERSON. DON'T INDUCE VOMITING UNLESS
ADVISED BY A PHYSICIAN. OBTAIN MEDICAL ATTENTION IN ALL CASES.
Fire Fighting
Flash Point Method:TCC
Flash Point:104F
Lower Limits:0.9
Upper Limits:7
Extinguishing Media:THE NFPA CLASS B EXTINGUISHER.
Fire Fighting Procedures:WATER SPRAY MAY BE INEFFECTIVE. WATER MAY BE
USED TO COOL CLOSED CONTAINERS. IF WATER IS USED, FOG NOZZLES ARE
PREFERABLE.
Unusual Fire/Explosion Hazard:CLOSED CONTAINERS MAY EXPLODE WHEN
EXPOSED TO EXTREME HEAT. DON'T APPLY TO HOT SURFACES. NEVER USE
WELDING/CUTTING TORCH ON/NEAR CONTAINER, MAY IGNITE/EXPLODE.
Accidental Release
Spill Release Procedures:STOP &/CONTAIN DISCHARGE SAFELY. KEEP SOURCES
OF IGNITION AWAY. VENTILATE AREA. USE NON-SPARKING TOOLS. COVER
W/INERT MATERIAL. KEEP OUT OF DRAINS, SEWERS/WATERWAYS. CONTACT
FIRE AUTHORITIES. NOTIFY L OCAL HEALTH & POLLUTION CONTROL
AGENCIES.
Handling
Handling and Storage Precautions:DON'T STORE >120F. DON'T CUT/PUNCTURE
CONTAINER. DON'T WELD NEAR CONTAINER. KEEP CONTAINER TIGHTLY CLOSED
WHEN NOT IN USE. USE W/ADEQUATE VENTILATION.
Other Precautions:GROUND CONTAINERS WHEN POURING & LIMIT FREE-FALL TO A
FEW INCHES. AVOID CONTAMINATED RAGS/IGNITABLE ORGANIC MATERIALS.
INTENTIONAL MISUSE BY DELIBERATELY CONCENTRATING & INHALING THE
CONTENTS MAY BE H ARMFUL/FATAL. DON'T BREATHE VAPORS/MIST.
Exposure Controls
Respiratory Protection:IN OPEN AREAS DURING SPRAY APPLICATION, USE
NIOSH/MSHA MECHANICAL FILTER RESPIRATOR/IN RESTRICTED AREAS, USE
NIOSH/MSHA APPROVED CHEMICAL MECHANICAL FILTERS/IN CONFINED AREAS,
USE NIOSH/MSHA APPROVED AIR LINE TYPE RESPIRATORS/HOODS.
Ventilation:GENERAL DILUTION/LOCAL EXHAUST TO KEEP TLV BELOW ACCEPTABLE
LIMIT DURING WELDING/FLAME CUTTING ON COATED SURFACES.
Protective Gloves:NATURAL RUBBER/NEOPRENE/BUNA N/NITRILE
Eye Protection:GOGGLES
Other Protective Equipment:APRON
Work Hygienic Practices:REMOVE/LAUNDER CONTAMINATED CLOTHING BEFORE
REUSE. WASH HANDS THOROUGHLY BEFORE EATING & USING WASHROOM.
Supplemental Safety and Health
% VOLATILE BY VOLUME: 50.96-57.73.
Chemical Properties
Boiling Pt:B.P. Text:300-416F
Vapor Pres:2
Vapor Density:>1
Evaporation Rate & Reference:SLOWER THAN BU AC
Percent Volatiles by Volume:(SUPP)
Stability
Stability Indicator/Materials to Avoid:YES
WELDING
Stability Condition to Avoid:SPARKS, OPEN FLAME, HOT SURFACES, SOURCES
OF IGNITION.
Hazardous Decomposition Products:CO, CO2 & OXIDES OF NITROGEN.
Disposal
Waste Disposal Methods:DISPOSE OF IAW/FEDERAL, STATE & LOCAL
REGULATIONS. DON'T FLUSH TO SEWER, WATERSHED/WATERWAY.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.